Electrolux error repair e20 washing machine

Another damage to the electrolux washing machine is error with e20 code. In the washing machine that has the display, it looks e20 code error, while the washing machine that does not have a display shows blinking on the start lights, glow red lights 2 times then silent a moment then blinking back 2 times.

Electrolux e20 washing machine repair steps as follows::

1. If we read the manual from the washing machine, then this damage indicates the delay of charging water, therefore pay attention to the condition of the water pump used.
2. If the water pump is already working, watch for the faucet cover, Make sure the faucet cover is open.
3. At the inlet hose of the machine there is a filter gauze, open the engine inlet hose and using the tang pliers, remove the filter gauze, there is usually a lot of dirt and then wipe using a used toothbrush.
4. If the water still does not flow too, the possibility of damage to the water valve that is not working perfectly. Remove the water valve then measure by using ohmmeter to measure the resistance. Usually ranges from 5 to 10 ohms. If not measured most likely valve water damaged, in this case the water valve must be replaced new.
5.  Usually after the valve replaced this water, the machine can work normally again. In exceptional and rare cases is damage to the mother board of the washing machine.

Measurements on the water valve

So how to fix electrolux error e20 washing machine, hopefully useful.