How to remove the drum from the front loading washing machine

This article will be explained about how to dismantle the front loading washing machine, the following explanation:

First of all, open the two screws behind the table top (top cover), the position behind the arrow.

After the screw opens, push the table top back and lift it up, the table top is open.

Next is removing the control panel.

Pull the detergent drawer off. Remove the detergent box by removing the screws - screws. Press the control panel support clip (red circle) while pulling out. Then release the control panel.

Remove the lower panel by removing the screw near the drain pump, then remove the fastening clip from the bottom while pulling on the panel.

Remove the screw - screw in the circle to release the front plate.

Remove the gasket binder and door switch.

Well, like this when it's released ...

Remove the drum hangers and the ballast concrete.

Remove the shock breaker fastener.
The drum is ready to be removed.

Remove the bonding bolt on the outer tub around it. Remove the outer tub.

Open pulley using the T. key.

Now, after the pulley is released, it will look like the picture on the side. The parts are rather difficult and must be extra careful - removing the drum from its outer. Usually quite difficult, especially if the age is old.
Don't be too eager to open it, you can - you can bend as you can ... he ... he ... he.
The way out is to lift the outer part (held by the hand just to be safe), then the middle part of the axle (usually with a hole because the screw thread) is inserted into a round iron, but do not get the screw thread ... After safe, hit the iron with a fixed heart - heart. If you are patient, the drum will be released safely.

Well, this is the shape of the drum that has been released ... just continue our work, want to replace bearings or axles or just want to clean the drum.
For installation, just reverse the steps above.