How to Fix Sharp Washing Machine Module

Sharp washing machine is a washing machine that often suffered the most damage to the system module. Actually this repair is rarely done by washing machine technicians because it takes a long time. Most washing machine technicians do not want to bother if it turns out the damage is the module. Do not think long and replace it with a new module that costs approximately 700rb for the original and with solution menggatinya with china module which is cheaper. It was adjusted to the owner's own washing machine finances.

These improvements I actually do because of my financial terms, and I also do not recommend to the washing machine technicians to fix the module itself because it takes a long time and customer satisfaction is reduced to our old service.

For the remedial step is to remove all existing silicone cover on the washing machine module. Clean until clean by using a screwdriver minus or cutter. and the earliest check is the fuse and output output voltage on each elco foot.

As the case that much I experienced was damage to the trafo. because if the measured voltage is not visible. As the following picture explanation.

Remove the transformer and measure it with a multimeter. The primary and secondary windings. If it breaks it could mean a broken transformer. The most damage is the breaking of the fuse and the transformer. If there is no fuse it can also resistor measuring 4.7ohm s.d. 47ohm that connects to the primary winding.. 

Other damages for example if the motor does not rotate although the servo motor is still good are two TRIAC as an example of the size of BCR8PM as well as a 2n2nF / 1KV tantalum capacitor.

And other damage can you develop your measurement by checking other components such as zener diodes, elco bloated and SMD components. Like any other experience I've ever experienced is a sharp protect module. If the first turn on okay then protect the alarm, this case including cases that make me stressful. And the conclusion is the short SMD capasitor component.

Keep your measurements down to the smallest things possible because things that we are not physically aware of are good but the components that are actually damaged in the washing machine module do not work properly.

The final stage is to try it by pairing the module with a washing machine unit. If it is fixed just to restore it by mending again with silicone glue. This is done to avoid splashing water when it is being used during the washing process.

Sumber