Repair Dry Parts Washing Machine

Washing Machine The main function there are 2 that is to wash by rotating the laundry back and forth with soaking washing water detergent, the other function is to dry the laundry that was in rinse by rotating the laundry with high rotation so that water can come out from the fabric fiber that we wash up almost dry, as for the automatic washing machine with the front door there are additional functions again that is the heater so that the laundry does not need in the drying again after the washing process.

On this occasion we will share about the damaged 2-tube (manual) washing machine on the dryer part, when the washing process starts to sound because the rotation is unstable so that the drying tube collides with the washer's wall / body so that the sound of the washing tub wall / body washer.

*) The first step we see is the position of the tumble dryer tube? If so check the bottom of the dryer tube if there is any laundry in the washing machine so as to make the tumble dryer tube.

*) What if the first step is done and it turns out we do not go to the next step that we open the back cover of the washing machine and we check the buffer axle shaft tube made of rubber like a bowl and the middle there is a kind of bearing whether there is a torn rubber parts or there worn bearings if yes replace the buffer axle with the new tube.

*) What if the normal tube support bosses do not cause our tilt to proceed by checking the feet of the drying tube motor which is at the bottom, to support the dryer motor for any of the 3 legs damaged / broken or even out of the peer, if yes change to 3 feet with a new leg, because if only one of the results are also unbalanced, can also cause the slope.


*) What if the 3 steps above has been done then the last step we start is by removing the dryer tube by opening the top of the washing machine to remove the tube and previously we loosen the bolt binder between the tube with the dryer motor at the bottom of the tube, after regardless we check whether the axis tilted / crooked ?? if the crooked possibility is very small because the length of the ax is only about an inch while the shaft is made of steel more than 10mm in diameter.

Most likely the axle tube as we experienced, as the tube tilt as shown in the picture on the side because there is corrosion in the base after we replace with tube as straight as a result the tube is not tilted and noiseless again, and the round tube dryer so stable ,

As a note for the 4th step / case this is rarely the case, usually only one of the 3 steps above is able to complete this job (repair the washing machine that sounds on the washers) beside this is the picture of the tilting tube dryer as it is there is corrosion at the base of the axle in the tube, our analysis of this happens because there is damage to the washer dryer on the dryer because there are some clothes that are caught outside the tube so the tube dryer jammed then in the long term is not in use / not in reparation, the cloth / clothing that stuck in the wet tube of this dryer finally made corrosion.

May be useful