The price for an SANYO Electronic washing machine 1 tube washing machine when I asked the Service Center about $ 60. Not including the cost of the service, with a 1-month warranty if installed by a technician from the SC. If we buy and install it ourselves, there is no guarantee.
After being told to the owner of the washing machine, with the consideration of such a large price, finally objected too.
Finally I offer a Made in China replacement module, with prices and installation costs much cheaper than the original Module. But I also did not dare to provide a warranty for the replacement module.
With some consideration, finally the owner of the washing machine chose the second option.
And so it's also done.
After being told to the owner of the washing machine, with the consideration of such a large price, finally objected too.
Finally I offer a Made in China replacement module, with prices and installation costs much cheaper than the original Module. But I also did not dare to provide a warranty for the replacement module.
With some consideration, finally the owner of the washing machine chose the second option.
And so it's also done.
Some things that need to be considered in the installation of this universal Module
- Look closely at the Wiring diagram of the old Module, which is roughly applicable to this Universal Module. Although so far I have observed wiring diagrams of all 1 tube washing machine brands are almost the same and can be replaced with Universal Modules.
- Remove the old (original) Water Level Switch Detector and replace it with the default Water Level Switch Detector from the Universal Module. Pay attention to the installation not to be reversed. Because if inverted the module will not work.
- Also note the installation of the output connection from the motor, not to be reversed too. Because if it is turned upside down when operating in the SPIN position or drying the tube it will not rotate instead of the rotating disc.
- Do not forget to connect the picture pin Switch on the module so that the supply voltage of 220V AC can enter the module.
- On the control switch panel try to close the existing gap by using Silicone sealant so that it is not easy to enter the water, and after being installed, cover it with plastic film which is usually used to overlay the windshield or motorcycle trim.
That's all I can say. Please try if you get damage to the 1 tube washing machine module, and it feels the price is too expensive.
In addition, not all module washing machine brands are expensive. But the average must be above $ 40.
0 comments:
Post a Comment